SEM910
The following commands are issued by typing
radio
and then the subcommand followed by the
subcommand parameters if any.
Command Description
help
Displays command list
banner
Displays power on banner for the radio in the SEM
defaults
Resets the radio parameters to the factory shipped values
masterbw [
10..80]
(Master only)
Displays master to slave bandwidth in percentage
Sets master to slave bandwidth in 10 percent increments between 10
and 80 percent. Remainder of bandwidth is shared among slaves for
slave to master communication
Default
=
50
maxslaves [
0..15]
(Master only)
Displays value currently in use
Sets the maximum number of slaves the master will allow to register.
Default
=
15
network [
0.. 35]
Displays current SEM network number
Sets the network number for the SEM
Default
=
0
power
[500|100|10]
Displays radio output setting:
500= +27dBm (Default)
100= +18dBm (+20dBm ERP with 2db gain antenna)
10= +10dBm
Sets radio output power
show
Displays radio parameters that have been modified from factory
settings
radio
spid [
0..254]
Displays service provider ID
Sets service provider ID
Default = 0
help
Displays list of sub-commands under the
radio
command.
banner
Displays the power on banner of the radio inside the SEM.
defaults
Replaces any modified parameters with the factory default values.
masterbw
Sets the percentage of the total RF bandwidth to be allocated to the Master
transmissions. Ranges from 80 percent to 10 percent in 10 percent increments.
Default is 50 percent. The RF bandwidth not allocated to the Master transmissions
is shared among the slave SEMs for transmissions to the Master.
©
2000- 2004 Cirronet
™
Inc
26
M-910-0003 Rev -
