www.RFM.com
Technical s1.678.684.2000
Page 69 of 82
© 2010-2012 by RF Monolithics, Inc.
E-mail:
DNT90 Integration Guide - 05/10/12
Figure 8.6.1.7
Figure 8.6.1.7 shows the
I/O Parameters
tab contents, corresponding to Bank 5. All GPIO ports are con-
figured as inputs. The 12-bit ADC input readings and DAC output settings are given in
Big-Endian
byte
order. Event flags are presented on the right side of the window.
Figure 8.6.1.8
Figure 8.6.1.8 shows the first
I/O Settings
tab contents, corresponding to Bank 6 GPIO configurations
other than alternate GPIO functions. This tab allows the direction of the GPIO ports to be set both for ac-
tive and sleep modes, and in the case of GPIO outputs, the initial power up states and sleep mode states
to be set. When GPIO ports 0 - 3 are configured as inputs, event interrupts can be set for them with check
boxes. The type of interrupt trigger is selected from the drop-down boxes to the right of the check boxes.
Periodic I/O reporting, reporting interval and enable/disable sleep I/O states and I/O binding can also be
configured under this tab.
