Configuring TRAP Transmitters
Page: 2
QS-TRAPTX-1
Press SET Sw
1X
LED1
flashes 1x
Press SET Sw To select
LED1 OFF:
Acknowledgement OFF
LED1 ON:
Acknowledgement ON
After selecting wait for
timeout
Wait 3
Seconds
LED 1 & 2
Flash 1x, then
LED1 is either
ON or OFF indicating
current Status
Configure Transmitter to request Acknowledge from Receiver
Acknowledgement Feature provides the user with LED indication
that the receiver has successfully received the transmitters
signal.
When activated the Transmitter includes an acknowledgement
request with each radio transmission.
The response from the receiver is indicated on the transmitter
via the RED / GREEN LEDs.
RF Acknowledgment from Receiver - Warning!
In theory if an RF signal can be transmitted one way then it can
be returned, in practice occasionally the received
acknowledgement many not penetrate as well as the
transmitted signal.
SET
Switch
Antenna
LED1
LED2
LED3
Flashes
constantly
in setup
Configuring Modes of Operation
To configure the modes of operation, undo the six
enclosure fixing screws to access the internal circuit
board.
The SET switch is used to configure the operating
modes.
The Following Modes can be configured
1. Acknowledgement back from the Receiver
2. Continuous or State Change Transmission
Transmitter Factory Default Settings
1. Acknowledgement OFF
2. Continuous Transmission
