1-1/2"
floor
2x4 Tie Plate
2x6 Truss Plate
2x6 Truss Plate
Step 14 Set Gables and 2x6 Truss Plate
4.
Layout 2x6 plate for trusses. Important: Start
the truss layout 19-1/2" from the back of the
gable plate. Then space trusses 24".
5.
Install 2x6 plate on the opposite side.
2.
Nail bottom edge of siding to
1x4 trim with 6d galv. nails.
3.
Install 2x6 plates 92" from the center of the building. When installed properly the 2x6 will
project 1-1/2" past the 2x4 tie plate. See detail below. Nail to floor with 16d nails.
1.
Install front and rear gables. The gable siding will
extend over the 1x4 trim on the lower wall panel.
The bottom gable plate should overhang the loft
floor the same distance on both ends. Nail gable
plate to floor with 16d coated nails. Use a 2x4 to
brace gables to floor.
Front Wall
Siding
19-1/2"
92" From Floor Center
24"
1x4 Trim Board