Step 8
Assemble Door Header
1.
Locate (2) two 2x10-10' boards.
2.
Cut these boards to a length of 99".
3.
Cut filler boards from leftover gable siding.
4.
Assemble the door header using 10d sinkers.
Siidng Fillers
2x10 Board
3.
Butt wall frames together
Do Not
nail these frames together so they can be separated later.
4.
Install a siding panel but do not nail along the long edge that overlaps the other wall frame.
You can nail this edge after the wall panels are installed. This will enable you to separate
the wall panels making them easier to handle.
5.
Cut the last siding panel to a width of 45". The last panel will extend 3-1/2" past the wall
frame.
6.
Separate wall panels and repeat procedure to assemble the other sidewall.
Step 7
Assemble 89-1/2" Long Sidewalls
X
X
X
X
X
X
24"
23-1/4"
89-1/2"
Wall Plates
24"
1.
Cut (2) two 2x4-8' to a length of
89-1/2". Position the boards together
and indicate with 'X' marks where
the wall studs will be located.
2.
Install pre-cut wall studs between the top & bottom plates.
Do Not Nail This Edge
89-1/2" Wall Frame
92-1/2 Wall Panel
