REXON MS10W2, Instruction Manual

Page: 24 / 36

2
4
Troubleshooting Guide
WARNING! To avoid injury from accidental starting, always turn switch OFF and
unplug the tool before moving, replacing the blade or making adjustments.
TROUBLESHOOTING GUIDE - MOTOR
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE ACTION
Brake does not
stop blade within
10 seconds. 1. Motor brushes not sealed or
lightly sticking.
2. Motor brake overheated from
use of defective or wrong
size blade or rapid ON/OFF
cycling.
3. Arbor bolt loose.
4. Brushes cracked, damaged,
etc.
5. Other.
1. Inspect/clean/replace brushes. See
“MAINTENANCE” section.
2. Use a recommended blade. Let cool
down. See “Removing and installing the
blade” section.
3. Retighten. See “Removing and installing
the blade” section.
4. Replace brushes.
5. Contact the Service Center.
Motor does not start. 1. Limit switch failure.
2. Brush worn.
3. Fuse blown or circuit breaker
tripped on home panel.
1. Replace limit switch.
2. Replace brushes. See
“MAINTENANCE” section.
3. Verify there is electrical power at the
outlet.
Brush spark when
switch released. 1. Brush worn.
2. Other.
1. Replace brushes. See
“MAINTENANCE” section.
2. Contact the Service Center.
TROUBLESHOOTING GUIDE - SAW OPERATION
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE ACTION
Blade hits table. 1. Misalignment. 1. Contact the Service Center.
Angle of cut not
accurate. Can not
adjust miter. 1. Miter table unlocked.
2. Sawdust under table. 1. See “Miter angle adjustment” section.
2. Vacuum or blow out dust. WEAR EYE
PROTECTION.
Cutting arm wobbles. 1. Loose pivot points. 1. Contact the Service Center.
Cutting arm will not
fully raise, or blade
guard won’t fully
close. 1. Pivot spring not replaced
properly after service.
2. Sawdust build-up.
1. Clean and lubricate moving parts.
2. Contact the Service Center.
Blade binds, jams,
burns wood. 1. Improper operation.
2. Dull or warped blade.
3. Improper blade size.
4. Wood is moving during cut. 1. See “Basic saw operation” section.
2. Replace or sharpen blade.
3. Replace with 255 mm diameter blade.
4. Use clamp to secure workpiece to
fenceunit and table.
Saw vibrates or
shakes. 1. Saw blade not round /
damaged / loose.
2. Arbor bolt loose.
1. Replace blade.
2. Tighten arbor bolt.