Rexel Auto+ 100, Instruction Manual

Page: 4 / 74

4
Introduction
Thank you for choosing this shredder from Rexel. We are sure
it will serve you well, but please take a little time to study these
instructions to ensure you get the best out of your machine.
Decal Panel
Safety First
To guard against injury, the following basic safety precautions
must be observed in the set-up of this product.
• Ensure the machine is plugged into an easily accessible power
outlet, and ensure the cable is not likely to trip up a passer by.
• Any attempt to repair this unit by unqualified personnel will
invalidate the warranty. Please return to supplier.
• Unplug your shredder before moving it or when it is not in use
for an extended period of time.
• Do not operate with a damaged power supply cord or plug,
after it malfunctions, or after it has been damaged in any
manner.
• Do not overload electrical outlets beyond capacity as this can
result in fire or electrical shock.
• The socket-outlet should be installed near the equipment and
shall be easily accessible.
• Do not alter the attachment plug. The plug is configured for
the appropriate electrical supply.
• Do not use near water.
• Do not use aerosol dusters or cleaners.
• Do NOT spray anything into the shredder.
• Do NOT load the autofeed chamber with junk mail, magazines,
bound documents etc.
Although this shredder has been designed to comply with UL
60950 safety standards including the “probe accessibility tests”,
do not operate the shredder near children or pets.
There is a ‘cross shaped’ integral safety device, located on
the left of the internal loading bay (see Fig 4 above), which
is designed to prevent the shredder from operating when the
loading door is open. You must NOT under any circumstances
tamper with with this switch, add any object into the cross-
shaped interlock switch other than the interlock actuator, as to
do so would activate the cutting blades.
m
Description of product parts
U
On/off switch (at rear of machine)
U
Important safety symbols (see shredder control
panel below)
U
Low sheet count entry slot
U
Credit card slot
U
Auto/Standby button
U
Reverse button
U
Continuous Jam Boost button
U
Loading door button
U
Loading door
U
Paper stack viewing window
U
Bin full/Loading door open, Cool down and Paper
Jam indicators
U
Pull out bin with viewing window
A
B
C
D
E
F
G
H
I
K
J
L
Specifications
Sheet capacity
(Low sheet count entry slot)
Sheet capacity
Autofeed chamber
Auto shutdown
Duty cycle
Run time from cold
Volts / Hz
Amperage
Motor watts
Rexel Auto+ 100
6 sheets (80gsm)
100 sheets (80gsm)
After 2 minutes
5min ON / 30min OFF
10 minutes
230V / 50Hz
1.5 Amps
200 Watts
Shredder Control Panel
Safety First
This means no aerosols.
This means you should be careful because long hair can
become entangled in the cutting head.
This means don’t reach into the feed opening of the
cutting head.
This means be careful of ties and other loose clothing
which could become entangled in the cutting head.
This means keep children away from shredder.
This means be careful of loose jewelry which could
become entangeld in the cutting head.
This means no CD/DVD.
This means no oil lubricant (oil sheets only).
Reverse Forward Auto
Cool down indicator – This means the machine is
cooling down
Bin full / loading door open indicator
– This means
the bin is full or open or the loading door is open
Paper Jam indicator – This means there is a
Paper Jam