Revv Owner’s Manual - 13
Cabinet Lighting
- The cabinet lighting jack on the rear of the amplifier is
used to connect the D20 to Revv speaker cabinets. Because the Revv
badge on our cabinets lights up, you can illuminate the cab badge with
this jack. Simply use the 4 pin Din cable provided with all Revv cabinets
and connect the D20 to the cab lighting connector on the cabinet.
MIDI In
- The MIDI In jack is used exclusively with the Two notes Torpedo
Embedded.
Note: The main purpose of this is not only saving more than 6 presets, but
also allowing on-the-fly changes of the virtual cabinet setting live. For
example, a guitarist with a MIDI/loop switcher choosing between “pre-
sets” during a set may want their clean tone to use a 2x10, their rhythm
tone to use a 2x12, their lead tone to have reverb, and so on and so forth.
USB Connector
- The USB connector will connect your computer to the
D20 in order to use Two notes Remote software. Use the provided USB
cable to do so and edit the presets, create new ones from scratch, or
load your own third-party Impulse Responses!
Bias Test Jacks
- The red and black test jacks on the amplifier will give you
the ability to check and set the bias of the 6V6 power tubes with a multi-
meter. So in the case you need to replace tubes, you can do it on the fly!
Balanced Output XLR and Ground Lift
- The balanced output XLR jack is
a direct output from Two notes Torpedo Embedded. By connecting this
output to front of house or an audio interface you can capture D20’s tone
with no need for a cabinet or microphone! The ground lift switch will
defeat the ground on the D20 should you encounter ground noise from
other equipment you have connected.