Revv Owner’s Manual - 12
Rear Panel Layout
Mains Power Connector
- When plugging the amplifier into the mains A/C
wall receptacle, always make sure the amplifier power and standby
switches are in the off position. The Required voltage and fuse ratings are
marked on the amplifier underneath the mains input. Verify that they are
correct for your electrical mains supply before plugging it in.
The mains input is a 2 part assembly on the D20 , not only will it allow you
to plug the amplifier power cable into it, the main fuse is also a part of the
assembly. Should the fuse ever blow on the amplifier, you will find the fuse
in this assembly as well. There is also a spare fuse compartment built in so
you can keep a spare fuse with you. The fuse type is marked on the rear
of the amplifier.
HT Fuses
- The HT fuse is in place to protect you and the amplifier from
overload conditions. Always replace them with the same type and rating
only! Always unplug the amplifier from the mains before replacing the
fuses. Fuse requirements are marked on the rear panel of the amplifier.
The HT fuse protects the High Voltage to the tubes from overloads.
3.0