Inputting your Printer’s Unique Calibration Settings
Every printer we send out goes through several calibration procedures to make sure
your selected extruder is perfectly tuned to your printer. The following printer settings are
optimized to each printer:
Dual Extruder O
ff
set
,
Z-Height O
ff
set
,
and
Print Centre
.
These
calibrations are found on the
Delivery & Manufacture Information
form and need to be
entered into the MatterControl slice settings under the
Settings
>
Printer
>
Extruder
and
Settings
>
Printer
>
General
section when
Advanced
settings is selected as shown.
Note - The Z-O
ff
set setting is used when there is a change to the height of the Glass Build
Plate - such as adding blue painters tape or any other surface which may change the height
of the build area. Refer to the instructions in the Nozzle Clearance Settings section if
changing the bed height.
13
Summary of Contents for INFINITY 3D INF3D-AF1
Page 1: ...USER MANUAL...
