11
11
11
11
When to Charge
First-time use — before using the wireless microphone the first time, charge the batteries in the
microphones for eight hours (or overnight) in the Charger Base.
Recharging — when the YELLOW LED starts to flash intermittently on the microphone the battery
has 30 minutes remaining. Over time (years), batteries gradually wear down and require longer
charging times. This is normal. Always return microphones to the Charger Base when not in use.
The Lithium Polymer rechargeable batteries that power the microphones are not user serviceable.
Please contact Revolabs (www.revolabs.com) or your AV service provider for replacement
instructions and to assure the proper disposal method is used.
Warning: Never dispose of
batteries in a fire because they may explode.
Pairing Wireless Microphones to Base Station
“Pairing” creates a link between the wireless microphone and the Base Station with a unique
electronic serial number. When the microphone and Base Station have been previously paired, the
microphone will automatically try to connect to the Base Station whenever it is lifted from the
Charger Base.
Note: Microphones in new systems must be paired to the Base Station with each microphone
assigned to a unique channel on the base unit.
Remember, microphones are always muted (flashing RED LED) when they are removed from
the Charger Base and the
MUTE
button needs to be pressed to make it “live” (flashing GREEN
LED).
If a microphone is lifted from the Charger Base and the LEDs continuously flash alternating RED and
GREEN, and/or the Base Station LED flashes alternating RED and GREEN, the microphone needs
to be paired to the system. Make sure that all other microphones are properly paired, and that the
Base Station is powered on, before proceeding to pair an individual microphone. By noting which
microphone channels are already in use (paired), it will be obvious which channel to use for pairing
the microphone.
Microphone Pairing Instructions
1. First make sure the microphone is turned OFF (no LED activity). If the unit is ON, press and hold
the
MUTE
button for 10 seconds until the LED turns solid RED (do not release when you hear two
beeps). Release the button to turn the unit off.
2. Next, place the microphone unit into pairing mode by holding the
MUTE
button down for seven
seconds. The LED will turn solid GREEN and then solid RED. Release the
MUTE
button. The
microphone unit is now in pairing mode.
3. Within one minute, push and hold the button for the desired channel on the Base Station for
seven seconds to enter into pairing mode. The LED for that channel will be solid RED until pairing
starts, as indicated by Solid RED followed by a quick GREEN flash, then switching to flashing
RED on both the microphone and the Base Station (muted audio). Pairing is now complete.
