15
INSTALLATION OF THE LOG SET
The log set (2 long fiber logs and 4 shorter ceramic logs) for the DVD400 is included in the
master carton.
Check to ensure that there is no damage to any of the logs.
It is very important to install these logs in their proper position to ensure safe operating
conditions.
Make sure that the logs are not placed directly in the burner flame. SEE THE FOLLOWING
LOG PLACEMENT DIAGRAM :
WARNING : Dangerous operating conditions may occur if these logs are not positioned in
their certified locations.
1. Open the front (vent on right hand side) door by lifting the tabs on the easy-latch door
fasteners. Then, while holding the door, unfasten the latches. Swing the door down gently
until it rests on a supporting surface.
2. Remove the logs carefully from their packing.
3. Place the bottom fiber logs on the log holding surface beside the main burner. Make sure
that the notch at the end of the log clears the front burner .
4. Place the four top logs as shown in the diagram above.
Slight repositioning of the logs may be necessary after the appliance is turned on and the
exact flame location is visible.
INSTALLATION OF THE GLOWING EMBERS
CAUTION : Use only the amount (Log for each burner) and type of ember material supplied
for this appliance. The use of other materials on the burners can create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement please contact
your nearest REVERSO dealer for an approved ember replacement kit.
