- 22 -
panel. Display should be assembled in a visible place, as close as possible driver's eye level. Avoid selection of direct sun and very warm places. LCD
contrast and refresh rate is optimized for 10-40C temperature range. OLED is characterized with about 180deg. view, high contrast and refresh rate in
wide range of temperatures (-40C...+85C). You will find many examples of assembly on our webpage.
2.6. Additional instructions for assembly
The most important notes are given in Chapter 2.1. Notes of the LCD/OLED assembly are given in Chapter 2.4. Additional assembly guidelines are
listed below:
•
before connecting the signal to the device, make sure you connect the appropriate cable
(check the signal with a multimeter or
oscilloscope) – warranty does not cover damage caused by unprofessional and improper installation,
•
while connecting / disconnecting the plug wires do not pull the cables - only for housing,
•
before installing plan ahead component locations (central unit, keyboard, display, temperature sensors) having regard to the length of wires,
•
it is recommended to mount the unit with a USB cable connected to the UTCOMP and lead the USB cable outside (possibility to change the
device parameters from a PC at any moment) - protect USB connector e.g. with pendrive connector housing,
•
you can connect UTCOMP to PC (using USB cable) and pre-configure it before assembling (details described in next chapters),
•
if you connect UTCOMP outside the vehicle,
do NOT connect it directly to car battery charger
(there's required DC voltage in range of
+8V...+32V)