Revel AIR ROMA Series Instruction Manual Download Page 11

11

WOBBLE:

Note:

Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber

grommet. If the fan was mounted rigidly to the ceiling it will cause excessive vibration. Movement of a
few centimetres is quite acceptable and does not suggest any problem.

To Reduce the Fan Wobble:

Please check that all screws which fix the mounting bracket and down
rod are secure and blade screws are fastened securely.

NOTE: 

This fan has been precision balanced at the factory and may need re-balancing. (Balancing kit
supplied can be used if required).

NOISE:

When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations
and frequency signals superimposed in the electricity for off-peak hot water control may cause a change
in fan motor noise. This is normal. Please note that this is not a product fault and as such is not covered
under warranty – All electric motors are audible to some extent. 

Please allow a 24-hour 

“breaking-in” period, most noises associated with a new fan disappear during this time.

CARE AND CLEANING:

•    Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush

or lint free cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.

•    Do not soak or immerse your ceiling fan in the water or other liquids. It could damage the motor or

the blades and create the possibility of an electrical shock.

•    Ensure that the fan does not come in contact with any organic solvents or cleaners.

•    To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.

•    The motor has a permanently lubricated ball bearing so there is no need to oil.

NOTE: Always turn OFF the power at the mains switch before performing any maintenance or

attempting to clean your fan.

AFTER
INSTALLATION

TECHNICAL
INFORMATION

Ceiling Fan Model                Rated                   Rated Power              Rated Power                     Net 

                                             Voltage                       (Motor)                       (Lamp)                      Weight

ROMA48HSXX
ROMA48JHXX             

220-240V AC 50Hz                60W                             N/A                           5.0kg

ROMA48HSB22XX
ROMA48JHB22XX      

220-240V AC 50Hz                60W                     2 x Max.15W                    5.8kg

ROMA56HSXX
ROMA56JHXX             

220-240V AC 50Hz                65W                             N/A                           5.5kg

ROMA56HSB22XX
ROMA56JHB22XX      

220-240V AC 50Hz                65W                     2 x Max.15W                    6.3kg

ROMA fan instructions_Oct20.qxp_Layout 1  15/10/20  11:19 am  Page 11

Summary of Contents for ROMA Series















Reviews: