Retsch PP 35, Manual

Page: 28 / 48

Operating the Device
28
Fig. 24: Fill in the feed material

Put the cover on the pressing tool.

Proceed as described in Chapter 6.7.1.

Close the [Programme end] message after the end of the program.

Open the press, pull out the tool sliding tray and remove the steel ring with the sample.
6.4.3 Reusing the steel ring

Insert the steel ring into the tool included in the scope of supply.

Put the die onto the sample in order to then carefully knock the sample out with the aid of a
hammer.

Clean the steel ring and remove any residual clinging feed material so that it can be used
again.
Fig. 25: Remove sample out of the steel ring.