PerkinElmer Optoelectronics
20
6.5 Verifying Slave Mode Operation
Note:
In order to verify the Slave Mode you must have made provisions for the required
external signals in the frame grabber interface as described in section
4.1.2
on
page 6.
1. Make sure that the camera is powered down.
2. Set DIP Switch #1 and DIP Switch #2 to OFF, OFF to select the Slave
Mode.
3. Power up the camera.
4. Set the Line rate of the LT (Line Transfer) signal to:
41
+
£
N
frequency
MCLK
rate
Line
5. Set LR active in accordance with slave mode timing.
6. Make sure that the gray shade strip is displayed. Adjust the external light
source and camera gain as required to obtain a barely visible display.
7. Adjust LR timing and observe light amplitude of signal..
8. Power down the camera and configure it for your specific application.
