NOTE
: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
page 4
5. Fan Assembly.
yoke set screw
downrod
yoke cover
canopy
pin
clip
motor
housing
set screw hole
set screw
hanging ball
stop pin
A
B
electrical wiring
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
4in. downrod provided to use with the 12 in.
downrod included with the fan (or an extended
downrod, sold separately). [
If you wish to use the
4in. downrod, please proceed to instructions
following the dotted line below.
]
If you do not wish to use the 4in. downrod, you
will need to remove the hanging ball from the 4in.
downrod for use with the 12in. (or longer)
downrod. To remove hanging ball, loosen set
screw on hanging ball, lower hanging ball and
remove stop pin. Slide hanging ball off the
original downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of
the hanging ball. Tighten set screw securely.
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of motor housing.
Remove pin and clip from motor housing yoke.
Slide downrod through canopy, canopy cover
and yoke cover. [
Note
: Canopy cover must be
turned with shiny side
toward
the motor.]
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
canopy cover
