background image

47-0036-00 • RevA • 2017-08-021

 Tech Support Line (877) 260-5578

www.ResolutionProducts.com

WARRANTY

Resolution Products, Inc. will replace all non-portable products 

that are defective in their first five (5) years, and all portable 

products that are defective in their first two (2) years.

IC NOTICE

This device complies with Industry Canada license-exempt 

RSS standard(s). Operation is subject to the following two 

conditions:
(1) This device may not cause interference, and

(2) This device must accept any interference, including 

interference that may cause undesired operation of the 

device.

Le présent appareil est conforme aux cnr d’Industrie 

Canada applicables aux appareils radio exempts de licence. 

L’exploitation est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et

(2) L’utilisateur de l’appareil doit accepter tout brouillage 

radioélectrique subi, même si le brouillage est susceptible 

d’en compromettre le fonctionnement.

IC: 21031-ANANDAT1

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is 

subject to the following two conditions:
(1) This device may not cause harmful interference.

(2) This device must accept any interference that may be 

received, including interference that may cause undesired 

operation.

Changes or modifications not expressly approved by the 

Resolution Products, Inc. could void the user’s authority to 

operate this equipment.

FCC ID: 2AASJSTP-103

CE DECLARATION OF CONFORMITY

Hereby, Resolution Products, Inc. declares that this is in 

compliance with the essential requirements and other relevant 

provisions of directive 1999/5/EC.

(This declaration can be translated to other languages via a 

myriad of translation tools found on the Internet.)

Specifications

Physical Specifications

Dimensions With Feet
Dimensions Without Feet

Weight

Mounting Fasteners

8.8 x 4.8 x 3.3 inches (22 x 12 x 8.4 cm)
8.8 x 4.8 x 1.2 inches (22 x 12 x 3.0 cm)
18 oz (510 grams)
#4 or #6 screws (not included)

Environmental Specifications

Operating Temperature

Maximum Humidity

32°F to 120°F (0°C to 49°C)

85% non-condensing relative humidity

Device Specifications

Battery Life

Wireless Range
Screen Resolution
Screen Size

4 Hours

300 feet in open air
1024 x 600 pixels
7 inches diagonally

Accessories

Power Supply
WiFi DeviceLink

RE012-13
RE926RX

Certifications

RE657

FCC, IC

Specifications subject to change without notice

Summary of Contents for Cryptix HeliTouch RE657









Reviews: