14
9
Check oxygen connection (if in use).
Attach the accessories according to the setup descriptions (see “Adding supplemental
oxygen” on page 8).
Starting therapy
CAUTION
The Clinical mode
is only for clinicians. If the device is operating in clinical mode
press the power switch
at the back to re-start the device in patient mode
.
1
Fit your patient interface (mask or catheter mount) as described in the user instructions.
2
Lie down and arrange the air tubing so that it is free to move if you turn in your sleep or
arrange the tubing so it is comfortable in your wheelchair.
3
To start treatment, press
or
if the SmartStart/Stop function is enabled, simply breathe
into your patient interface and treatment will begin.
Stopping therapy
You can stop therapy at any time, simply remove the patient interface and press
to stop
airflow
or
if SmartStart/Stop is enabled, simply remove the patient interface, and treatment
will stop automatically.
Notes:
•
SmartStop may not work if
Full face
or
Trach
is selected as mask type; the High Leak
alarm or the Low Min Vent alarm is enabled; “Confirm Therapy Stop“ is enabled; or the
mask-fitting feature is running.
•
When the device is stopped and operating in standby mode with an integrated
humidifier connected, it will continue to blow air gently to assist cooling of the
humidifier’s heater plate.
•
Masks with high resistance (eg, paediatric masks) may cause the operation of the
SmartStop feature to be restricted.
•
When using with oxygen, turn off oxygen flow before stopping therapy.
Turning off the power
1
Stop the therapy.
2
Press the power switch
at the back of the device once and follow the instructions on
the display.
Note:
To disconnect the device from the mains power pull out the power cord from the
power socket.
