The T6RWP Smart Thermostat wireless thermostat comes unbound from the factory and binding is required during
installation (see previous page).
The binding operation described below is only required if:
•
The T6RWP thermostat or Receiver box is replaced.
•
The T6RWP thermostat or Receiver box has incorrect or no binding data stored.
- Thermostat will indicate the Alert message: NO RECEIVER BOX BINDING
- Receiver box status LED remains green blinking (no communication from thermostat)
- Receiver box status LED does not light up (not bound).
To rebind
3.
Put the Receiver box into binding mode by pressing the Heat button for 3 sec.
- The first LED will flash amber
4.
Enable binding on the thermostat:
- Enter the advanced menu by pressing the
button for 5 sec.
- Navigate to BINDING
- Select BIND and the signal will be sent
5.
When binding is successful:
- Thermostat will show SUCCESS
- First Receiver box status LED will show green
Note: When the Receiver box has been bound before first press with a small pin
the pinhole for approximately
3 seconds to reset the binding. All LED’s will
flash amber for a moment.
When binding is NOT successful:
- Thermostat will show FAILED
- Receiver box will exit binding after 3 min.
RF communication might be too far or is blocked due to wrong location of the
Thermostat or Receiver box. Try to move closer or re-locate and re-bind again.
System type setting
(optional)
After binding with a 2-channel Receiver box the System type of the thermostat can optionally to be set to enable
heating and also hot water control.
1.
In the Advanced menu navigate to System Type.
- Select Heat for only heating or 2 zone control
- Select Heat + H/W for heating and hot water control
2.
Exit the Advanced menu and the binding and setup is complete
9
