Rescea RVH-AXP35-LCD, User Manual

Page: 14 / 20

3. Attach Gauge to Valve.
4. Press Repressurize Button and wait unit the Gauge reads 0 MPa.
5. Remove Gauge and attach Plug.
6. To remove LCD Port or LCD Port Cover, while pressing LCD Port Lock Button turn
LCD Port or LCD Port Cover counterclockwise until it stops. Carefully remove from
Housing Port.
7. Open back cover. Refer to INSTALLING CAMERA IN HOUSING, 3.
8. Unplug SONY RM-VPR1 Remote Commander Cable from camera and remote.
9. Carefully remove camera from housing.
CAUTION! Neglecting to wash salt and other contaminants from the housing may result in
damage the housing raising the risk of leakage during future use. Damages due to the lack of
proper cleaning and maintenance is not covered under warranty.
ARMS & LIGHTS INSTALLATION
The housing is equipped with two (2) M10/P1Ball Joint Base sockets and comes with a dual
grip and tray assembly which can be attached using two (2) tripod screw sockets located at
the bottom of the main body. Please use as needed.
CAUTION! Use the grip and tray assemblies provided. Leakage or damage due to the use of
other than assembly provided is NOT covered under warranty.
MAINTENANCE
CAUTION! Allowing saltwater and contaminants to dry on housing can damage functions and
O-rings possibly causing water leakage. Clean with fresh water only, using a soft, dry cloth to
wipe away water.
1. After extended periods of non-use, soak empty housing, making sure back cover is
properly attached, in lukewarm for half a day. Manipulate all buttons and dials several
times. Using a soft, dry cloth wipe away water.
After use in salt water, wash off salt and other contaminants by soaking empty housing,
back cover is properly attached, thoroughly in a bucket of fresh water (lukewarm) for 10 to
20 minutes. Manipulate all buttons and dials several times. Using a soft, dry cloth wipe
away water.
2. Remove Back Cover, LCD Port or LCD Port Cover and using the O-ring Removal Pick,
remove the O-rings.
3. Perform O-RING GREASING & MAINTENANCE as instructed below before re-installing.
O-RING GREASING & MAINTENANCE ( 1)
※
CAUTION! DO NOT use silicone grease other than that provided by Seatool/Recsea.
1. Using the O-ring Removal Pick, remove Back Cover and LCD Port or LCD Port Cover O-
rings.
2. Clean sand, salt, other contaminants and old grease from O-rings.
3. Clean O-ring grooves and O-ring contact surfaces using a clean cotton swab.
4. Visually and physically check each O-ring by running it through finger tips, feeling for
cuts, cracks or any other defects that may cause leakage. Such defects will cause water
leakage, so be sure to replace defective O-rings. Be careful not to stretch or pull the O-
rings too much.
5. Squeeze a rice grain sized bead of silicone grease on your thumb and forefinger. Taking
care not to pull or stretch the O-ring too much, uniformly spread grease on each O-ring.
Too little grease may cause an O-ring to twist in the groove, possibly causing water
leakage.
13