VAL Set-up
VAL options
VAL (Variable Angle Lift) comes as standard on the 159 Kg (25 stone) model (without low profile
seat) and it allows the rise angle to be set to support individuals to a standing position. Choose
from three positions 10º(a), 20º(b) or 30º(c). The higher the angle the lower the front of the chair
becomes, providing more support when moving from a sitting to a standing position. A simple pin
system allows you to set the angle required. Please note – An enclosure skirt can only be fitted on
the standard VAL setting (c).
20˚
25cm
10˚
30cm
30˚
20cm
a
b
c
To alter the angle take the following steps. Ensure the area around the chair is clear of any
obstructions as you firstly, need to tip the chair forward so it rests on the back and the arms.
VAL Technology - angle alteration
Step 1
Tip the chair forward so it rests on the floor on both the end of the arms and top of the backrest
ensuring that the pins on either side of the chair are visible. When tipping the chair over ensure that
you take care to protect the back and arms when they touch the floor.
43
Step 2
Remove the clips from both pins on either side of the chair. Then remove the pins and place the
bar level with the required setting – a, b or c and then place the pins back into the required holes
(same place on both sides).
Step 3
Put the clips back into place on both sides.
Step 4
Bring the chair back up to its normal resting position on its base.
Pin
Clip
42
