ReplayTV RTV4040, User Manual

Page: 37 / 102

Chapter Two: Connecting your ReplayTV
17
f. Try to turn the power on and off again. If you succeed, your hand is not covering
the infrared detector.
g. Move your hand to a different place on the front of the unit and repeat steps e and
f. Keep repeating in this manner until you can’t turn the power on and off. At this
point, your hand is covering the infrared detector.
2. Connect and affix the IR blaster.
a. Plug the IR blaster into the IR BLASTER connector on the back of ReplayTV.
b. Peel off the protective cover from one of the emitters on the IR blaster. This will
expose the adhesive material on the infrared emitter for placement onto your cable
box or satellite receiver.
c. Affix the adhesive side of the infrared emitter to the dark plastic area directly over
the center of the infrared detector.
Note: If you only want ReplayTV to control one device, hide the unused emitter behind
the equipment, away from any detectors.
After you have connected the IR blaster, you will need to provide ReplayTV with the
setup code number for your cable box or satellite receiver. You will do this during the on-
screen Quick Setup setup process.
Affix the IR blaster directly
over the infrared detector
Locating the infrared detector