5
0037857-00_BEDBWAC 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
03 DESIGN
04 BEFORE USE
05 DURING USE
The bath with Aqua-Comfort system is equipped with a fi xed fan installed under the bathtub and
a jet pump. The Champagne nozzles (combined air and water nozzles) are located at the base of
the bathtub. When the Aqua-Comfort system is activated, these nozzles convey preheated air from
the fan into the bath, while the pump generates fi ne jets of water. This creates tiny air bubbles for a
pleasant and relaxing massage. At the same time, the therapeutic nozzles massage your back and
feet with water.
The jet pump and fan are controlled via a control panel on the side of the bathtub.
- Rinse out the bath with cold water.
- Close the bathtub drain.
- Fill the bath with hot water.
Important:
Since water must fi ll part of the piping system before the bathtub can be fi lled, it takes
some time for the water to visibly collect in the tub.
To enable the use of Aqua-Comfort, fi ll the bath up to around the overfl ow with the user(s) inside.
Press the key on the side of the bathtub once to switch
on the pump and the fan together.
The LED illuminates when the system is switched on.
Press the key again to switch the system off.
If the
LED fl ashes when you press the key and only the
fan starts,
there is not enough water in the bath. In this case, add more water.
Safety shutdown
The pump switches off automatically 20 minutes after activation.
The pump remains in standby mode and can be reactivated at any time.
Operation