61
Fixscreen
®
150 (F)
en
9 • Motor adjustment (upper/lower limits)
9.1 • Detecto Rensonmotor Safety First
The end points of the Detecto Rensonmotor Safety First are not adjusted by RENSON. They can
easily and quickly be installed due to the automatic detection of the end points. For more informa-
tion, go through the installation instructions of the motor.
9.2 • Somfymotor & Renson projectmotor
ADJUST UPPER AND LOWER END POINT SETTING AGAIN!
The upper and lower end point is adjusted in the factory.
Adjusting upper end point:
Upper end point is adjusted in the factory of Renson and the bottom bar, including the sealing
strip, is fully retractable (FH≤2800mm)) or partly retractable (2800<FH≤6000mm).
In case of a retractable bottom bar, make sure it does not hamper the fabric.
Adjust the upper end point for end use.
Adjusting lower end point:
The lower end point is adjusted at ± 400 mm from the bottom of the box. Adjust the lower end
point completely until the bottom of the screen, with a margin of 10 mm (for the sealing strip).
The adjustment depends of the motor type.
Tip:
in case the electricity works take place after the assembly of the screen, a temporary
power cable can be used to set the end points of the solar protection.
