Renogy Rover 100A, Manual

Page: 15 / 36

14
Mounting Recommendations
NEVER INSTALL THE CONTROLLER IN A SEALED ENCLOSURE WITH FLOODED
BATTERIES. GAS CAN ACCUMULATE AND THERE IS A RISK OF EXPLOSION.
1. Choose Mounting Location — place the controller on a vertical surface protected from
direct sunlight, high temperatures, and water. Make sure there is good ventilation.
2. Check for Clearance — verify that there is sufficient room to run wires, as well as
clearance above and below the controller for ventilation. The clearance should be at least 6
inches (150mm).
3. Mark Holes
4. Drill Holes
5. Secure the charge controller.
WARNING
6 inches
warm air
(150mm)
cool air
6 inches
(150mm)