Operating Manual
Rev.: 2019-05-06
17 / 18
1. Remove screw (A) from the threaded hole (1).
2. Turn the adjusting disc a half-notch.
- Notch (Y) over threaded hole (2) = rotate clockwise
- Notch (Z) over threaded hole (2) = rotate anti-clockwise
3. Insert screw (A) into threaded hole (2) and tighten.
In the state as shown, no other notch-hole combinations are permitted, since the change to the
crimping dimensions and/or force would be much too great. This could result in damage to the
tool and the crimping die sets.
Threaded hole 1
Notch Y
Notch Z
Threaded hole 2
10 Disposal
Do not dispose of the tool or its accessories in household waste.
For disposal of the battery and the charger, please follow the information given in the charger’s
operating instructions.
RENNSTEIG recommends using a licensed waste management company to handle disposal.
Alternatively, the tool and its accessories can be returned to RENNSTEIG or a service centre.
11 Warranty
All RENNSTEIG crimping tools are covered by the full German statutory product warranty of 24
months or 4 maintenance cycles (whichever occurs first). The warranty period always commences
when supplied; in cases of doubt, proof of purchase documentation must be shown.
Within the guarantee period, the product warranty covers the rectification of all damage or
faults affecting the tool, where such damage or faults are traceable to material or manufacturing
defects.
Figure 16
Tool setting example: