Operating Manual
Rev.: 2019-05-06
12 / 18
$
A positioning guide can be used to position the connectors. For use without a positioning guide,
assemble as shown in Section 8.1.1.
1. Select the crimping die set as appropriate.
2. Push the closed crimping die set – as shown in Figure 5 – into the socket on the die until the
lower piece of the die set can be loosely screwed into place using the M4x16 screw.
3. Press the Start button on the crimping tool briefly to close it so the upper part of the die set
can be screwed into place (figure 6).
4. Now tighten both screws.
5. Place the positioning guide onto the M4x16 screw as shown in Figure 8 and secure using the
thread contained in the locator. (Figure 9)
8.2 LED display meanings
8.1.2.2 Example for rotated contacts (Figure 8, 9)
0[
Figure 8
Figure 9
LED display
Status/cause
Action
No LEDs illuminated
The tool is switched off. Press the Start button
(see Section 7.4).
Green LED (5) is
illuminated
The tool is ready for
use.
Green LED (5) not
illuminated (jaws
opening)
The crimping tool is
returning automatically
to its starting position.
Green LED (5) flashes
Battery charge level
insufficient.
Recharge or replace
the battery.
Green LEDs (6)
Battery charge level
indicator