8
Wall Mounting PCX Series Loudspeakers
The PCX Series and the Passive UniBeam technol-
ogy delivers inherent downward bias, asymmetrical
coverage, and constant directivity deliver incredibly
consistent coverage, even when flush mounted. The
PCX Series was designed to be flush mounted in most
applications, and the included wall mount bracket
enables safe, simple installation.
As the installer you must insure that the wall or other
mounting surface is capable of safely supporting the
weight of the array and wall bracket plus the safety
margin legally required for your territory. Weights for
the PCX Series plus wall bracket is as follows:
• PCX4: 11 lbs./5 kgs.
• PCX8: 17 lbs./7.7 kgs.
• PCX16: 31 lbs./ 14.1 kgs.
PCX Series loudspeakers are too heavy to be supported
by gypsum wallboard alone, you must anchor the
brackets to structure able to support the weights listed
above.
Wall Bracket Instructions
• Disassemble the bracket into the wall and loud-
speaker halves by removing the 12 mm bolts and
star washers. Remove the three, 6 mm Phillips-
head screws from the back of the loudspeaker
using a #3 Phillips screwdriver. Be sure to use a #3
Phillips, using a #2 may damage the screws.
• Mount the loudspeaker half of the bracket to the
loudspeaker cabinet using the three 6 mm Phillips
screws. Use thread locking compound to prevent
the screws from loosening.
• The wall half of the bracket is intended to be
installed with the bolts facing up. This allows the
loudspeaker column to rest on the wall before
tightening the nuts and locking splay angles.
• Follow the instructions on the following page for
the type of wall to which you are mounting. If you
are mounting to a wall type other than those listed
on the next page, you must insure that the method
you use can safely support the weights listed.
PCX8 and Wall Mount Side View
