16
Fixed Install Interconnections, continued
Interconnecting -RD units
• Analog or AES signal (if desired) can be
looped by paralleling the wires at the
Phoenix terminals. (Note, not shown on
diagram, see -RN diagram for Analog/
AES looping)
• AC mains power looping is not available,
each cabinet in an array must have its
own power cable.
• Ethernet/Dante can be looped by
utilizing the Dante Secondary port as a
“Loop Out.” In this application the Dante
ports act as a two-port gigabit switch.
Each looping connection will count as a
switch hop for Dante latency. Renkus-
Heinz recommends only looping within
a single array, connect arrays in a star
configuration to the network switch.
ICLive X units are shipped with the
Dante ports in switched mode.
AC Mains Power
Ethernet/RHAON II/Dante
AC Mains Power
AC Mains Power
