59
Users Manual
ICL-FR
Updating DSP Firmware (Continued)
Step 3:
Wait for the Firmware transfer to complete. When finished, control will be returned to the dialog window. Select “Done”.
Note: If you are installing the DSP Firmware into a multiple module Array disconnect the signal cable from its normal connection to the
Master (lower) Module and insert it into the Primary Ethernet input on one of the Slave (upper) Modules and reset the Dip Switches on the
Slave Module to designate it as a Master (set to 00). Then proceed to update its DSP Firmware just as you did for the lower module.
When the new DSP Firmware transfer is complete to all the modules, select Done. Then disconnect the signal cable from the upper mod
-
ule and reconnect it to the lower Master module. Finally, reset the upper module’s dip switches to their original settings.
Please be aware that the Mutes and the Analog Input Pad will be On after the update completes and may need to be reset.
GENERAL INFORMATION
Your Renkus-Heinz loudspeaker contains no user-serviceable parts and all service should be referred to qualified service personnel.
Hum and Noise Problems
If you encounter hum or noise problems in your system, please refer to the Loudspeaker User’s Manual that came with your loudspeaker,
Renkus-Heinz form RH 508 Rev B. It includes detailed instructions for locating the source of these problems and solving them.
Summary of Contents for ICL-FR
Page 77: ......
