7
Hardware Inputs, Outputs & Indicators
To connect an IC-R-II array to the RHAON network, you first make the hardware connections, and then (if you are using CobraNet for
digital audio distribution) assign signal routing using RHAON software. Make power and analog connections first since they will become
inaccessible once CobraNet and AES/EBU are connected.
Primary & Secondary CobraNet Inputs
ST connectors; when both are connected, changeover to
Secondary is automatic if Primary fails.
Analog Inputs 1 & 2
Phoenix 6-pin connector
ID Dipswitches
Primary/Secondary AES/EBU Inputs
ST connectors
240 V AC
IEC Power
Connector
ACTIVITY LED flashes when the connector is active, glows steadily when data is streaming. SPEED LED glow when connected but inactive, turns Orange
to indicate a faulty connection.
WINK LED glows when Wink with LED is enabled in RHAON
FAULT LED glows when a hardware error condition has been detected
Power LED Glows when amplifier power is On
Master Rear Panel Indicators
Slave Rear Panel Indicators
Rear Panel Connectors
