36
g) Display settings
• Set the option Leon or LeoF in the menu Leon-LeoF.
Leon:
The display is permanently on.
LeoF:
The display switches off after approx. 20-30 seconds after the last button is pushed.
Push any key to activate the button again.
h) Display alignment
• Set the option Led in the menu Leon-LeoF.
• Use the buttons UP or DOWN to turn the display alignment by 180°.
i) IR receiver
• Set the option Iron or IroF in the menu Leon-LeoF.
Iron:
IR receiver is switched on; the devices may be controlled with the enclosed IR remote
control
IroF:
IR receiver is switched off; the devices may not be controlled with the enclosed IR re-
mote control
j) Use with an external DMX controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 1-7 free DMX channels depending on DMX operating mode.
DMX operation always takes precedence over any other mode. Once a signal is pending at the
DMX input DMX IN, the other operating modes are deactivated. The display shows the DMX
starting address.
Setting the DMX starting address
• Set the desired DMX starting address (001-512) in the menu A001-A512.
Setting the DMX operating mode
• Set the desired number of DMX channels with the option Ch 1-Ch 7 in the menu A001-A512.
