Renkforce 1423363, Operating Instructions Manual, Page: 56 / 132

56
Snooze function (snooze)
• When the alarm signal sounds, briefly push the button “ SNOOZE/LIGHT ” ( A2 ) on the
top of the projection radio alarm clock. The respective symbol D2 or D3 will flash.
The alarm signal is interrupted for approx. 5 minutes and then restarted.
You can repeat this as often as you like.
• Terminate the snooze function prematurely by briefly pushing the button “
ALARM
”
(
A6
). The respective symbol
D2
or
D3
will stop flashing.
Stopping the alarm signal
• When the alarm sounds at the set alarm time, it can be ended by briefly pushing the
button “ ALARM ” ( A6 ).
• If no button is pushed, the alarm signal will be ended automatically after 2 minutes.
f) Selection of the temperature sensor
• Briefly push the button “ +/CHANNEL ” ( A7 ), to switch between the three channels for
the outdoor sensors. The standard channel is 1.
To the left of the display for the measured values of the outdoor sensor (
C10
),
the respective active channel number will appear.
• To automatically display all three channels for approx. 3 seconds in sequence, keep
the button “ +/CHANNEL ” ( A7 ) pushed for approx. 3 seconds until a sound signal is
emitted. Release the button again.
• To terminate automatic mode, briefly push the button “ +/CHANNEL ” ( A7 ) again.
• The reception level is displayed using the bar chart C9 . If no bars are displayed, the
sensor has either not been found or the connection has been interrupted.
g) Frost alarm
• If the outdoor temperature drops to below 3 °C to -2 °C, the display will indicate the
frost alarm(
C8
) and flash evenly.
• The symbol will disappear again once the temperature climbs over 3 °C or drops
below -2 °C.