en
1 Introduction
After initial start-up, check whether a newer software version is available for
the EASY view+.
The version number of the software installed on your EASY view+ is displayed
on the bottom right of the screen after switching on (see Chap. 5.1).
Software updates are available on our website at
www.renfert.com/p918
.
Enter the following item number: 2400 3000�
1.1 Symbols used
This manual contains symbols also found on the appliance itself with the following meaning:
Danger
Immediate risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of injury due to electrical current.
Caution
Risk of damage to the unit if the instruction is not followed.
Notice
A general notice that improves and eases use.
The appliance complies with applicable EU directives.
Within the EU, this device is subject to the provisions of the directive 2002/96/EC
(WEEE directive).
►
List, special attention
• List
-Subordinate list
⇒
Instruction / required action / entry / order of tasks:
You are prompted to perform the specified action in the given order.
♦
Result of an action / reaction of the device / reaction of the program:
The device or program responds to your action, or because a particular event occurred�
Other symbols are explained when displayed�
2 Safety
2.1 Correct use of the unit
The system is used for digital stereo-magnification in 2D and 3D in real-time and for documentation.
2.2 Unapproved Use
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself�
2.3 Ambient conditions for safe operation
The appliance should only be operated:
• indoors,
• up to 2,000 meters above sea level,
• at an ambient temperature of 5 - 35 ºC [41 - 95 ºF] *),
• at a maximum relative humidity of 80 % at 31 ºC [87�8 ºF], linear reduction up to 50 %
relative humidity at 35 ºC [95 ºF] *),
•
with mains electricity supply provided that the voltage fluctuation is within 10 % of the rated value,
• with Pollution Degree 2,
• with Overvoltage Category II�
*) The unit can be used at a temperature of 5 - 30 ºC [41 - 86 ºF] and at a humidity of up to 80 %� At temperatures of
31 - 35 ºC [87�8 - 95 ºF] the humidity must reduce proportionately to ensure that the unit can be operated (e�g� at
33 ºC [91,4 ºF] = 65 % humidity, at 35 ºC [95 ºF] = 50 % humidity)� The unit should not be operated at tempera-
tures above 35 ºC [95 ºF]�
- 4 -
