Renfert 1822-0000, Instruction Manual

Page: 18 / 68

14. Accessories
No. 1821-0101 Stand for benchtop units,
WxHxD: 230 x 680 x 290 mm
[9.062 x 26.772 x 11.426 inches]
No. 1821-0200 Premix spatula
No. 1820-6500 Bowl, incl. paddle, 65 ml
No. 1820-6510 Paddle, 65 ml
No. 1820-6520 Bowl, 65 ml
No. 1820-0200 Bowl, incl. paddle, 200 ml
No. 1820-0210 Paddle, 200 ml
No. 1820-0220 Bowl, 200 ml
No. 1820-0500 Bowl, incl. paddle, 500 ml
No. 1820-0510 Paddle, 500 ml
No. 1820-0520 Bowl, 500 ml
No. 1820-0700 Bowl, incl. paddle, 700 ml
No. 1820-0710 Paddle, 700 ml
No. 1820-0720 Bowl, 700 ml
No. 1820-1001 Bowl, incl. paddle, 1000 ml
No. 1820-1010 Paddle, 1000 ml
No. 1820-1020 Bowl, 1000 ml
Subject to modifications.
15. Disposal instructions
for countries in the EU
To conserve and protect the environment, prevent
environmental pollution and improve the recycling of
raw materials, the European Commission adopted
a directive that requires the manufacturer to accept
the return of electrical and electronic units for proper
disposal or recycling.
Within the European Union units with this symbol
should not therefore be disposed of in unsorted do-
mestic waste:
For more information regarding proper disposal ple -
ase apply at your local authorities.
16. Error List
Error Possible cause corrective action
ON/OFF switch fails to
work.
• Unit not connected to the power
outlet.
• Unit fuse blown.
• Faulty/damaged power cord.
• Check the power supply.
• Replace the fuse (refer to Sec. 8.3).
• Have the unit repaired.
Motor fails to start. • Motor fuse blown.
• Motor defective/damaged.
• Replace the fuse (refer to Sec. 8.3).
• Have the unit repaired.
No or insufficient vacu -
um build-up.
(“Err” shown on the dis-
play + audible signal)
• Inlet filter blocked.
• Seal surfaces dirty.
• Vacuum pump defective/dam -
aged.
• Vent valve defective/damaged.
• Clean the filter (refer to Sec. 8.1).
• Clean the seal surfaces (refer to Sec. 8.2).
• Have the unit repaired.
• Have the unit repaired.
Vacuum reduction/ven-
ting too slow.
• Inlet filter blocked. • Clean the filter (refer to Sec. 8.1).
Vacuum pump conti-
nuously on.
• Bowl detection pin jamming. • Have the unit repaired..
Paddle fails to turn.
• Motor fuse blown due to paddle
overload.
• Clean the paddle and bowl.
• Replace the fuse (refer to Sec. 8.3).