SHIPPING, RIGGING, LIFTING AND ASSEMBLY: LE MODELS
15
1.800.627.4499
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
RENEWAIRE.COM
ASSEMBLY
4.6 CONNECT THE WIRING HARNESS
Wiring Harness Access Panel
Wiring Harness Routing
Access Panel Removal
Wiring Harness Connections
Internal wiring connections are required after modules are fastened together, and before connection
of unit supply power. For INH and RT models, the back module comes pre-wired with the exhaust air
blower wires being routed from the motor to the open end of the module. The wiring harnesses end in
plugs, ready for connection.
If the back module is equipped with isolation dampers, they are also pre-wired with the damper wires
being routed from the damper actuators to the open end of the module. The ends of the damper wiring
harnesses also end in plugs, ready for connection.
After the modules are joined together, open the electrical connection cover on the E-Box side of the
front module by removing screws in the access panel. The access panel is located in the upper left
corner of the front module, to the left of the E-Box.
www.renewaire.com (800) 627- 4499
www.renewaire.com (800) 627- 4499
Inside the access panel are low voltage and high voltage wiring connection compartments. The low
voltage compartment is the lower compartment and the high voltage compartment is the upper
compartment. Both compartments are open on the left side to access the wiring harness plugs that are
coming from the exhaust air blower and isolation dampers (if equipped).
www.renewaire.com (800) 627- 4499
www.renewaire.com (800) 627- 4499
Reach through the open left side of the compartments and into the rear module. Guide the wiring
harness(es) into the wiring connection compartments in the front module. Plug each wiring harness
into its matching connector, located in the wiring connection compartments. Secure excess wire with
wire ties.
