Reference Boards of RZ/G2H, RZ/G2M, RZ/G2N, and RZ/G2E
Start-up Guide
R01US0555EJ0100 Rev.1.00
Page 7 of 13
Mar. 31, 2022
Please Input : H'
000000
Work RAM(H'50000000-H'53FFFFFF) Clear....
please send ! ('.' & CR stop load)
Send the data of “bootparam_sa0.srec” from terminal software after the message “please send !” is shown.
After successfully download the binary, messages like below are shown on the terminal.
SPI Data Clear(H'FF) Check :H'00000000-H'00007FFF Erasing.
........Erase Completed
SAVE SPI-FLASH.......
======= Qspi Save Information =================
SpiFlashMemory Stat Address : H'00000000
SpiFlashMemory End Address : H'00000E67
===========================================================
SPI Data Clear(H'FF) Check : H'00000000-0000FFFF,Clear OK?(y/n)
In case a message to prompt to clear data like above, please enter “y”.
Write all necessary files using the addresses listed at Table 1 and turn off the power of the board by changing the
SW2402.
Table 1. Addresses for each file
File name
Address to load to RAM
Address to save to ROM
bootparam_sa0.srec
E6320000
000000
bl2-hihope-rzg2h.srec or
bl2-hihope-rzg2m.srec or
bl2-hihope-rzg2n.srec
E6304000
040000
cert_header_sa6.srec
E6320000
180000
bl31-hihope-rzg2h.srec or
bl31-hihope-rzg2m.srec or
bl31-hihope-rzg2n.srec
44000000
1C0000
tee-hihope-rzg2h.srec or
tee-hihope-rzg2m.srec or
tee-hihope-rzg2n.srec
44100000
200000
u-boot-elf-hihope-rzg2m.srec or
u-boot-elf-hihope-rzg2n.srec
50000000
300000
1.4
Setting U-boot
To set the board to SPI Boot mode, set the SW1002 as below:
