Renesas M30800T-CPE, User Manual

Page: 36 / 52

( 36 / 52 )
Chapter 4. Specifications
4.1 Specifications
Table 4.1 lists the specifications of M30800T-CPE.
Table 4.1 Specifications of M30800T-CPE
M16C/80 Series
Single-chip mode
M30802SGP
For internal RAM area: 10 KB
For internal ROM area: 256 KB
Applicable MCUs
Usable mode
Evaluation MCU
Internal emulation memory
Main clock (X
IN
)
Clock mounted on emulator (20 MHz: pre-mounted)
Switchable to external oscillator input.
Clock mounted on emulator (32.768 kHz)
Switchable to external oscillator input.
20 MHz (power voltage 4.5 to 5.5 V, divide-by-1, 0-wait)
32.768 kHz
Clock supply
Sub clock (X
CIN
)
Maximum operating frequency
Minimum operating frequency
Power voltage for MCU
and power supply
With the target
(set JP1 = EXT)
Without the target
(set JP1 = INT,
JP2 = 5.0 V)
4.5 to 5.5 V
(supplied through the LCC probe on the back
of the emulator board from the target)
Fixed to 5.0 V
(supplied from the emulator)
Basic debugging functions
Download, S/W break (max. 64 points), Program execution/stop
(allows free-run execution supporting S/W breaks), Memory
reference/setting (reference/setting C-variables, run-time
execution), Register reference/setting, Disassemble display, C-
level debugging, etc.
• 32K-cycle bus information is recordable (Address: 20 bits,
Data: 16 bits, MCU status: 12 bits)
• 2 trace modes are supported (Before Break mode/After Go
mode)
1 point (address match/bus match/possible to set up to 256 times
pass count)
Time between program start to stop is measurable
5 to 35 ° C (no dew)
-10 to 60 ° C (no dew)
Connect the LCC probe on the back of the emulator board with the
LCC socket mounted on the target.
DC 5.0 V ± 5%, 2 A supplied from external (prepare the power
supply separately)
RS-232C serial interface (Max. 115.2 kbps)
Real-time tracing function
Hardware break function
Execution time measurement function
Operating temperature
Storage temperature
Connection to target system
Power supply for emulator
Host machine interface