Renesas M306K9T2-CPE, User Manual

Page: 46 / 56

( 46 / 56 )
- Check that the emulator's target status LEDs.
If they are blinking, the emulator has not started
up properly. Check the settings explained in
"(1) Troubleshooting When the Emulator Starts
Up".
- Check that the USB cable is connected
properly.
- Check that an emulator other than the compact
emulator (such as PC4701, or PC7501) is not
connected.
- If the Clock tab in the Init dialog box is set to
External, check that an oscillator of the target
system is operating properly.
- If the Clock tab in the Init dialog box is set to
External, change it to Internal.
- If the Clock tab in the Init dialog box is set to
External, check that an oscillator of the target
system is operating properly.
- If the Clock tab in the Init dialog box is set to
External, change it to Internal.
Contact your local distributor.
Contact your local distributor.
Table 5.2 Error display and how to remedy it when starting up the emulator (2/2)
(2) Troubleshooting When Emulator Debugger PD30M Starts Up
Table 5.3 lists error messages and how to remedy them when starting up PD30M.
Table 5.3 Error message and how to remedy it when starting up PD30M
Error message Remedy
Communication ERROR.
Can't accept data.
Not compact emulator.
Target MCU is not given clock.
Target MCU is unable to reset.
Version of PD30M and the firmware
on the target are not same.
Please download the firmware
to target.
Connection to
the target system
-
-
Connected
Not connected
Connected
Not connected
-
-
The emulator system does not work properly.
- The emulator may be damaged. Contact your local
distributor.
LED display
Connection to
the target system
Problem & remedy
-
: OFF : Blinking
POWER CLOCK RESET RUN