Renesas Embedded Application Programming Interface, Reference Manual

Page: 79 / 204

Rev.1.01 2007.02.16
RJJ10J1643-0101
77
(Count source) Specify one from { RAPI_F1, RAPI_F2, RAPI_F8,
RAPI_TIMER_Y_UNDERFLOW}. The default value is RAPI_F1.
(Operating states set) Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The
default value is RAPI_TIMER_OFF.
(Output) Specify one from { RAPI_H_L_L, RAPI_L_H_H }. The default value is
RAPI_H_L_L.
• Specifiable definition values when timer RB is used (RAPI_TIMER_RB specified)
(Count source) Specify one from { RAPI_F1, RAPI_F2, RAPI_F8,
RAPI_TIMER_RA_UNDERFLOW}. The default value is RAPI_F1.
(Operating states set) Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The
default value is RAPI_TIMER_OFF.
(Output) Specify one from { RAPI_H_L_L, RAPI_L_H_H }. The default value is
RAPI_H_L_L.
(H8/300H)
RAPI_TIMER_V Uses timer V.
RAPI_TV_F4 Timer V counts on falling edges of internal clock φ /4.
RAPI_TV_F8 Timer V counts on falling edges of internal clock φ /8.
RAPI_TV_F16 Timer V counts on falling edges of internal clock φ /16.
RAPI_TV_F32 Timer V counts on falling edges of internal clock φ /32.
RAPI_TV_F64 Timer V counts on falling edges of internal clock φ /64.
RAPI_TV_F128 Timer V counts on falling edges of internal clock φ /128.
RAPI_TIMER_ON Sets the timer to start operating in __CreatePulseWidthModulationMode.
RAPI_TIMER_OFF Sets the timer to stop operating in __CreatePulseWidthModulationMode.
RAPI_COMPARE
_MATCH_A
Enables compare match A interrupt.
RAPI_COMPARE
_MATCH_B
Enables compare match B interrupt.
RAPI_OUT_H_L Sets to output a high the during primary period and a low during the
secondary period.
RAPI_OUT_L_H Sets to output a low the during primary period and a high during the
secondary period.
RAPI_RISING Selects the rising edge of TRGV pin input signal as active edge.
RAPI_FALLING Selects the falling edge of TRGV pin input signal as active edge.
RAPI_BOTH Selects both rising and falling edges of TRGV pin input signal as active
edge.
RAPI_TRGV_RIS
ING
Selects the rising edge of TRGV pin input signal as active edge.
RAPI_
TRGV_FALLING
Selects the falling edge of TRGV pin input signal as active edge.
RAPI_
TRGV_BOTH
Selects both rising and falling edges of TRGV pin input signal as active
edges.
RAPI_TRGV_
PROHIBITED
Selects that trigger input from TRGV pin is disabled.