7
R
888 Porter Rd. Muskegon, MI 49441 Phone: 231.798.8888 Fax: 231.798.4960 www.structuralconcepts.com
MAINTENANCE FUNDAMENTALS
Shelf Assembly Removal
•
Raise the front curved glass.
•
Remove and carefully set aside glass or wire
shelves.
•
For lighted shelving, unplug the light cord
and detach from the rear shelf support.
•
Slide light assembly back to unlock, then ro-
tate up to separate from brackets.
•
Slide rear support back to unlock and rotate
up to separate from brackets.
•
Remove brackets.
Note, it may be neces-
sary to remove the nylon shipping
bracket retainer.
Pliers will be required to
accomplish this task.
Light Fixtures
Light fixtures can be located on the underside of
each shelf assembly and at the top inside of
case.
Removal of lamp:
•
Rotate lamp (1/4 turn) so that pins are
aligned with socket slots and remove bulb.
Installation of lamp:
•
Align pins with slots in sockets.
•
Insert pins into socket and rotate 1/4 turn to
secure pin contacts in socket.
Removing the Rear Doors
•
Note: Doors are not interchangeable.
There is an inner and outer door. The outer
must be removed first and replaced last.
•
The outer door, is the right hand door (from
the service side or rear of the case). It can
be identified by a stop located at the lower
right hand corner to the inside of the case.
•
Move the doors toward the center of the
case.
•
Individually lift each door up toward the top
of the case and pivot the bottom of the door
out.
•
Reverse to install.
Cap
Plug
Receptacle
Rear Doors
Bracket Retainers
Light Assembly
Shelf Brackets
Rear Shelf Support
Glass Shelves
