11
Cleaning the heat-exchanger and combustion
chamber
1. Remove the inspection cover
1
.
2. Remove the flue gas brakes
3
.
3. Clean all exhaust gas passages
4
.
A special cleaning brush can be purchased as an
accessory
.
4. Clean or replace the flue gas brakes.
5. Check or replace the seals
2
of the inspection cover.
6. Clean the combustion chamber
5
with a vacuum
cleaner through the burner opening
6
.
Special boiler cleaning sets can be purchased as ac-
cessories for the REMKO industrial vacuum cleaner
.
Burner maintenance
1. Have the forced-air oil burner checked by authorised
personnel on a regular basis to ensure that the set-
tings are correct
2. To service the burner, please observe the instruc-
tions and information in the operating instructions.
3. For safety purposes, we recommend entering into a
service agreement!
1
2
7
6
S
3
4
5
Reassembly and reinstallation of the burner
1. Put together the disassembled parts in the opposite
order
2. Make sure that the inspection cover is positioned
properly and that the fixing screws are all tightened
uniformly.
If fixing screws are not tightened uniformly, this can
cause leaks!
3. Place the combustion chamber carefully into the unit
and align it properly.
4. Loosely turn the fixing screws of the combustion
chamber.
Final steps
1. Tighten the fixing screws of the combustion chamber
firmly.
2. Attach the lining plate and insulation.
3. Attach the exhaust connection properly.
Check the seal
7
and replace if necessary
.
4. Reattach all lines and connections and check them.
5. Put the unit into operation and check that all operating
modes are working properly.
Assembling the burner flange and the burner
1. Check the flange seal and replace it if necessary.
2. Attach the burner flange with the four screws to the
unit housing.
Pay attention to the “OBEN“ (UP, HAUT) label!
3. Tighten the upper screws.
6. Attach the flame tube to the flange by lifting the
burner slightly (3° incline).
7. Finally, tighten the lower screws.
30
4. Tighten the lower screws only
slightly so that the burner
flange can still be pulled to-
gether.
5. Slide the flame tube of the
burner into the burner flange.
Keeping a distance of 30 mm.
*
Exhaust gas losses are to be restricted in accor-
dance with §11 of the German Law on emissions
for small gas-fired units.
*
An operation/use other than indicated in these in-
structions is prohibited!
In the case of non-compliance, we assume no li-
ability and our guarantee becomes null and void.
Customer Service and
Guarantee
For the guarantee to be valid, the customer must com-
pletely fill out the “
guarantee certificate
” enclosed with
all heating units and send it back to REMKO GmbH &
Co. KG in a timely manner after purchasing the unit and
putting it into operation.
The units have undergone several tests to ensure proper
functioning at the factory. If there are still malfunctions
that cannot be fixed by the operator using the trouble-
shooting instructions, please contact your dealer or
contract partner.
Summary of Contents for HTL 150 FB
Page 2: ......
