How to Remove the Rechargable Battery:
1.
Press the head release button to open
the shaver’s head assembly.
2.
Pull the cutters off the cutter drives
that hold them.
3.
Use a torx screwdriver to remove
screws from back of shaver.
(A.)
4.
Pry housing halves apart, starting at
the head.
(B.)
5.
Unscrew PCB from housing.
(C.)
6.
Cut the 2 metal tabs connecting the
batteries to the printed circuit board.
(D.)
7.
Pull the batteries and the printed circut
board free from the inner frame and
dispose of properly.
(E.)
Cleaning Your Shaver
Remington
®
recommends cleaning
your shaver after every use for optimal
performance.
1.
Turn the shaver OFF.
2. Screen-
Do not use the
brush to clean the screen.
Instead, blow the shavings
out or rinse the screen
under cold or warm water.
3. Cutters and trimmer-
Use the cleaning brush
to sweep any loose hairs
from the cutters and
trimmers, or rinse/dunk
them in cold or warm
water. Do not use hot
water.
4.
After cleaning, return the
foil and head assembly
to their original position
on the shaver.
5.
If the shaver was rinsed
with water, or if you used
it in the shower, hold it
facing downward into the
sink, and turn it on for a
few seconds to dispel
additional water. A gentle
shake will also help.
6.
To clean the external
surfaces of the shaver, use a damp cloth.
Do NOT use strong detergents or other
chemicals.
7.
To dry, wipe the surface of the overall
shaver with a dry towel. Do NOT use a
hairdryer or heater to dry the shaver.
9
8
Cleaning & Maintenance
U.S. residents:
To order shaver accessories call
800.736.4648, visit
www.remington-products.com
or visit your local retailer.
To replace a cutter assembly that is
removed unintentionally:
1.
Hold the cutter in the middle. The blades
will not cut your fingers, so no special
handling techniques are necessary.
2.
Align the cutter so the little bar on the
bottom meets the opening in the clip.
3.
Press down on the center of the cutter
until it snaps into place. Do not push
down on the ends of the cutter, as you
may bend the cutter, reducing its ability
to cut cleanly.
4.
Do not separate the cutter’s blades from
the plastic pieces they are attached to,
as this may damage the assembly.
Rechargeable Battery
Removal
When your WSF-1000 reaches the end of
its useful life, the batteries must be
removed from the shaver and be recycled
or disposed of properly in accordance with
your state and local requirements. If this is
not required by law, you may elect to
dispose of the shaver without the batteries.
CAUTION: DO NOT PUT IN FIRE OR MUTI-
LATE YOUR BATTERIES WHEN DISPOSING
AS THEY MAY BURST AND RELEASE TOXIC
MATERIALS. DO NOT SHORT CIRCUIT AS IT
MAY CAUSE BURNS. DISPOSE PROPERLY IN
ACCORDANCE WITH YOUR LOCAL AND
STATE REQUIREMENTS.
A.
C.
D.
C.
D.
E.
B.
CS27905_WSF-1000_IB 8/24/06 4:17 PM Page 8
