Remington Smart Edge, Instructions Manual

Page: 4 / 112

4
C
GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to
allow time for your beard and skin to become accustomed to the new shaving
system.
, CHARGING YOUR SHAVER
• Ensure the product is switched off.
• Connect the adaptor to the charge stand and then to the mains.
• Place the charge stand on a flat surface.
• Place the shaver in the charge stand with the charge pins contacting.
• Charge for at least 24 hours when using for the first time.
• XF8500: At Low Charge the LED indicator will flash rapidly. When Charging
the LED will flash slowly. When fully charged the LED will stay on solid.
• XF8700: When charge is low ‘Lo’ will flash rapidly on the screen. When
charging, the LEDs flash in a clockwise rotation. When fully charged the
minutes will pulse ‘60’ minutes.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 24 hours.
• The adaptor automatically adjusts to a mains voltage between 100V and
240V.
• This appliance should be charged by approved safety isolating adaptors
PA-0510E(K) with the output capacity of 5.0 V dc; 1.0A.
• Quick charge feature: Your shaver is fitted with a 5 minute quick charge
feature that will provide enough charge for 1 shave (3 minutes).
F
INSTRUCTIONS FOR USE
, SHAVING
1 Make sure your shaver is properly charged.
2 Switch the shaver on by pressing the on/off switch.
3 Stretch the skin with your free hand so the hairs stand upright.
4 Hold the shaving head so that the foils touch your face.
5 Use short, linear strokes.
, TRIMMING
6 Switch the shaver on.
7 Push the trimmer release button up to activate the trimmer.
8 Hold the trimmer at a right angle to your skin.
9 To retract the trimmer, slide the trimmer release button down and push the
back of the trimmer head downwards until it locks into place.
ENGLISH