Remington S-1051 Instructions Manual Download

Page: 4 / 46

ENGLISH

FIN

HR/ SRB

INSTRUCTIONS FOR USE

SMOOTH AND SLEEK (Fig 1)

Before use, make sure hair is clean, dry and tangle-
free.

Plug in the unit and set to your desired temperature.
The bars on the LCD will flash until your desired
temperature is met.

For extra protection and best results, section hair
prior to straightening and spray with heat protection
spray. Always straighten the lower layers first.

Run the straightener through the entire length of the
hair, without stopping for a Smooth and Sleek finish.

Repeat only twice per section to prevent hair damage.

PROFESSIONAL CURLS (Fig 2)

Firmly grip a section of hair between the plates, close to
the roots.

Keeping tension firm gently rotate the styler whilst pulling
through the length of the hair section to the tips using the
curl guides to grip and shape the curl as you style.

Make sure to keep rotating the styler.

Remove styler and holding the hair length, allow the curl
to spring into shape.

Repeat using different size sections of hair for a natural
soft curl look.

IMPORTANT INSTRUCTIONS

Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating and cooling, place on flat, smooth, heat-resistant surface. Only hold unit at

the end of the handle.

This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.

CLEANING AND MAINTENANCE

Ensure the unit is unplugged and cool. To maintain the effectiveness of your product wipe
clean after use with a damp cloth. Do not use an abrasive cleaning fluid to clean, as damage
will occur.

SAFETY CAUTIONS

WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA is ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.

WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.

This product is not suitable for use in bath or shower.

THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT
IN USE.

Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their safety should give explicit
instructions or supervise the use of the appliance

Do not use any attachments with this styler, other than those supplied by Remington

Avoid allowing any part of the hot plates to contact the face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
This product is not intended for commercial or salon use.
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged,

discontinue use immediately and return the appliance to your nearest authorised
Remington

service dealer for repair or replacement in order to avoid a hazard.

Special tools are required for any examination, adjustment or repair. Unqualified repair

work could lead to hazardous conditions for the user.

We do not accept responsibility for damage to the product, persons or other item(s),

caused by misuse, abuse or non-compliance with these instructions.

FIG 1

FIG 2

080748_REM_IFU_S1051_20L.indd GB_2-GB_3

15.10.2008 11:12:50 Uhr