Cleaning your shaver:
TO ASSURE OPTIMAL PERFORMANCE, IT IS RECOM-
MENDED T H AT YOU CLEAN YOUR SHAVER AFTER EACH
USE. The cutting system of this shaver was designed t o
be cleaned by rinsing under warm running water or by
b r u s h i n g .
Cleaning your Remington
®
MicroFlex
®
TCT™ Shaver is
easy.
(NOTE: With the R-9300/-9350/R-TCT model, the brush
icon will blink to remind you to clean your shaver.)
■
Open the hairpocket by squeezing
on both buttons and rotating awa y
from the body of the shaver. You may
blow out the stubble thoroughly, or
rinse the shaver head in water. Rinse
both sides of the head assembl y.
■
At Least Once a Week:
For more complete cleaning, remove the cutter retainer
assembly from the hairpocket by turning the center knob
approximately 1/4 turn counter clock-
wise. Hold cutter retainer assembly as
shown, and remove head by turning
approximately 1/8 turn in the direction
shown. Brush clean both the head and
the cutter. Reassemble head to cutter
retainer assembly by aligning and turn -
ing head 1/8 turn in the opposite direction. Repeat this
process for each of the 3 heads. Clean each head and
cutter set one at a time to prevent mixing cutter compo-
nents.(These should be kept as sets). After cleaning,
place cutter retainer assembly in the hairpocket, and
secure by turning center knob
approximately 1/4 turn clockwise.
Caution:
Never put the shaver
completely under water.
Do not use any aggressive
cleansing agent as this ma y
destroy the shaver coatings.
■
To clean and lubricate your shaver’s cutters and head assembly,
apply Remington
®
Shaver Saver
®
(SP-4) Lubricant. The lubricant
helps remove hair clippings while reducing wear. A quick spray after
each shave keeps your shaver operating at peak performance.
Caution:
Do not remove or replace the head assembly while
shaver is running or plugged into an electrical outlet as it may
cause damage to the unit’s cutters.
■
Worn or damaged parts should be replaced with Remington
®
replacement parts only.
When is it time to replace our heads
and cutters?
It is very important to replace your heads and cutters
when necessary to insure a close, comfortable shave
without irritation. We recommend they be replaced
every 12 months. Here are some signs of head and
cutter wear, indicating that replacement is needed.
(NOTE:R-9300/-9350/R-TCT cutter icon,R-9200 &
R-9250- the yellow LED- will blink when it is time to
replace the cutters.)
Irritation:
As the heads get excessively worn there may be some
skin irritation. This would be especially noticed when
applying After Shave lotion.
When the cutters wear you may feel a sense of
“pulling”and a loss of closeness when you shave.
This is an indication that it is time to replace your
heads and cutters.
H a i r p o c k e t
Head
Cutter
