6
3. To re-activate StyleAdapt™ mode press the
K
button until the StyleAdapt™ indicator
is illuminated. Your air styler will now be learning about your hair and adapting the
heat again.
Create volume using the oval brush
•
To dry your roots and add volume, place the brush underneath the section close to
the roots and hold for a few seconds, lifting the hair as you dry.
•
Move the styler downward through the hair section.
•
Repeat this around the head.
•
Let the hair cool before further styling.
Create shaped ends using the 50mm brush
•
To curl the ends in, place the brush underneath the section close to the ends and
rotate the styler inwards allowing the hair to wrap around the barrel and hold for a
few seconds.
•
To curl the ends out, place the brush on top of the section close to the ends and
rotate the styler outwards allowing the hair to wrap around the barrel and hold for a
few seconds.
•
Repeat this around the head.
•
Let the hair cool before further styling.
Root volume using the root boost attachment
•
Push the root boost slowly into your roots towards the centre of your head.
•
Allow the hair to push against the root boost and hold the root boost there for up to
10 seconds.
•
Repeat until you have voluminous hair.
Cool shot
•
To set your style, press the cool shot button whilst styling then release it to reactivate
the heat.
Memory Function
•
Each time you use your styler it will automatically set itself to the last setting used.
OVERHEATING PROTECTION
In the event of overheating, your airstyler may stop unexpectedly. Overheating is usually
caused by a blocked inlet grille. Unplug your airstyler then check and clean the inlet grille
if required. Allow your airstyler to cool down before plugging it back in and using.
