Step 5 – The finishing touches
•
Use the clipper without an attachment comb for close trimming around
the base and sides of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair
clipper.
•
Place the reversed clipper at right angles to the head so the tips of the
blades lightly touching the skin and then work downwards.
CLEANING & MAINTENANCE
•
Your clipper is fitted with high quality blades.
•
To ensure long lasting performance of your clipper, clean the blades
and unit regularly.
•
Always keep the attachment guide comb on the trimmer blade.
After Each Use
•
Ensure the appliance is switched off and unplugged from the mains
before cleaning.
•
Brush the accumulated hair from the blades and body of the clipper.
Do not submerge the clipper in water.
•
To clean unit, wipe with a damp cloth and dry immediately.
•
Place a few drops of cutter or sewing machine oil onto the blades.
Wipe off excess oil.
Every Six Months
•
Remove the 2 screws retaining the fixed blade with a screwdriver.
•
Remove the blade set.
•
Brush out hairs from between the blades with a soft cleaning brush.
Do not remove the lubricating grease from the blades. It is not
necessary to remove the small moving blade from the unit.
•
If the moving blade has been removed this can be re-fitted by slotting
the moving blade holder over the pin in the centre of the interior
product head.
•
The groove on the moving blade just below the teeth should rest on
the plastic pressure arm which rides inside the groove. The fixed blade
should be assembled with the bevelled edge of the 2 screw holes
facing outward and fixed with screws.
•
Note that if the blades are not correctly aligned then cutting efficiency
will be impaired.
