4
GETTING STARTED
BATTERIES
• Your shaver requires 2 ‘AAA’ alkaline batteries (first set included).
1. Rotate the on-off switch/battery compartment cover counterclockwise to the
position just to the right of the
O
marking (Fig A) to unlock the battery compartment.
2. Pull the battery compartment cover downwards (Fig. B).
3. Insert batteries so that the (+) and (-) marks on the batteries face the same marks in
the battery compartment.
4. Replace the on-off switch/battery compartment cover and twist it to the
O
position
to secure it.
INSTRUCTIONS FOR USE
Switch the product on by rotating the on-off switch/battery compartment cover
clockwise to the
I
mark.
Always comb your beard or moustache with a fine comb before you start trimming.
FITTING AND REMOVING STUBBLE GUIDE COMBS (FIG. C)
To Fit
• Hook the front of the comb over the blade.
• Press the back of the comb down until it clicks into place.
To Remove
• Lift the tab on the back of the comb upwards until it comes free from the blade.
TO TRIM THE BEARD
1. Select your desired trimming length comb. If you are trimming for the first time start
with the maximum trimming length setting.
2. Turn the unit on.
3. Place the flat top of the fixed comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit
off, pull off the comb and brush the hair off.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above
steps without a comb attached to the blade head.
Place the flat top of the blade against the skin and slowly slide through the hair against
the direction of growth.
Shave in an upwards direction when shaving under the chin (Fig. D).
Summary of Contents for Omniblade HG1000
Page 2: ...2 g h C e h A h B h D f...
